Prevention and solution of conveyor belt breakage

1. Reasons for broken belt
(1) The conveyor belt tension is not enough
(2) The conveyor belt has been used over time and is seriously aging.
(3) Large pieces of material or iron smash the conveyor belt or jam.
(4) The quality of the conveyor belt joint does not meet the requirements.
(5) The conveyor belt joint is severely deformed or damaged.
(6) Conveyor belt is jammed
(7) The tension of the conveyor belt tensioning device is too large.
2. Prevention and treatment of broken belt
(1) Replace the conveyor belt that meets the requirements.
(2) Expired conveyor belts should be replaced in time
(3) Strictly control the loading of bulk materials and ironware onto the conveyor
(4) Replace the damaged connector.
(5) Increase the deviation-adjusting drag roller and anti-deflection protection device; if the conveyor belt is found to be jammed by the frame, it should be stopped immediately.
(6) Adjust the tensioning force of the tensioning device properly.
(7) After a broken belt accident occurs, the following steps can be taken:
① Remove the floating coal on the broken belt.
② Catch one end of the broken tape with a card board.
③Lock the other end of the broken belt with a wire rope.
④ Loosen the tensioning device.
⑤ Pull the conveyor belt with a winch.
⑥Cut the conveyor belt breaks.
⑦Connect the conveyor belt with metal clips, cold bonding or vulcanization, etc.
⑧After trial operation, it is confirmed that there is no problem, and then put into operation.